Table of Contents
Advertisement
3-9-2. Pinch Lift Cam and Pinch Cam Gear
1. Refer to Section 3-2 and remove the mechanism unit.
When you do this, make sure the mechanism is in
EJECT mode.
2. Refer to Section 3-9-1 and remove the pinch roller
lever assembly.
3. After removing the screw 1, undo the three clamps
2, then remove the opener mounting 3.
4. Remove the clamp 4 and the pinch lift cam 5.
5. Remove the pinch cam gear 6.
Assembly Notes:
1. Apply grease (VHJ-0100) around the shaft 7, all over
the teeth B of the pinch cam gear 6, all over the
teeth of the pinch lift cam 5, all over the cam grooves
A, and all over the "V Part C" of the opener mount-
ing 3. Apply grease (VHJ-0101) to the outside of the
shaft 8 and all over the top cam D of the pinch cam
gear 6.
2. Check that the positioning mark 0 on the OPT pinch
relay gear 9 is aligned with the arrow !- on the MC-
1 PWB assembly, as shown in Fig. 3-9-3. Then align
the square mark != on the pinch cam gear 6 with the
arrow !- on the MC-1 PWB assembly.
After that, align the round hole ![ on the pinch lift
cam 5 with the indentation !] on the pinch cam gear
6.
If you have carried out the above alignments and the
pinch roller will still not move up and down or per-
form the pressing movement correctly, refer to Section
3-15 and check the alignment of the gear wheels 1 and
2, the main cam, and the OPT pinch relay gear.
SVT-RA40/RA168
C "V" part
3 Opener
mounting
2 Clamps
6 Pinch cam gear
D
B
Fig. 3-9-2
!] Indentation
!- Arrow
!= Square mark
9 OPT pinch
relay gear
Fig. 3-9-3
1 Screw
5 Pinch lift cam
A
8 Shaft
4 Clamp
7 Shaft
!- Arrow on MC-1 PWB
assembly
0 Positioning marks on
OPT pinch relay gear
5 Pinch lift cam
