Temporarily Setting Up And Connecting Cp-1 Pwb Assembly; Installation Of The Front Panel - Sony SVT-RA40 Service Manual

1-3. Temporarily Setting Up and
Connecting CP-1 PWB Assembly
The following is an example of how to place and connect
the main board without a jig, when repairing the CP-1
PWB assembly.
1. Place the mechanism unit and main board up side
down as a whole on a flat surface with foil side of the
main board facing up.
2. Operete the unit using the buttons on TM-1 PWB and
TM-2 PWB.
CP-1 PWB Assembly (Foil side)
PW-1 PWB
Screws
Mechanism
Main Unit
TM-2 PWB
Cassette Compartment
Fig. 1-1-4
SVT-RA40/RA168

1-4. Installation of the Front Panel

When installing the front panel to the chassis after repaires
and adjustments.
1. Pressing down the door opener lever of the mechanism
2. Set the cassette door to half-opened state as shown in
n
Opened cassette door position does not install the front
panel to the chassis.
Jutted part of
Cassette Holder
Terminal Board
TM-1 PWB
main unit.
Fig. 1-1-5, and install the front panel to the chassis.
Front Panel
Cassette Door
(Position A)
Fig. 1-1-5
Door Opener Lever
Cassette Door
(Position B)
1-5