Table of Contents
Advertisement
3-15. Wheel Gear 2, Main Cam and OPT
Pinch Relay Gear
1. Refer to Section 3-2 and remove the mechanism unit.
When you do this, make sure the mechanism is in
EJECT mode.
2. Remove the clamp 1, then remove the wheel gear 2
2.
3. Remove the washer 3, then remove the main cam 4.
4. Remove the clamp 5, then remove the OPT pinch
relay gear 6.
Assembly Notes:
1. Apply grease (VHJ-0100) to the shafts 7, 8 and 9,
to the teeth of the main cam 4, and to the all over the
cam groove of main cam 4.
2. When fitting the OPT pinch relay gear 6, align it in
A B order as shown in Fig. 3-15-2. The alignment of
the part B is shown in Fig. A. Position the teeth of the
OPT pinch relay gear 6 so that the sixth tooth space
left of part A is aligned with the triangular mark on
the pinch cam gear 0. After aligning part B, refer to
Section 3-9-2 and check the positioning of the OPT
pinch relay gear, the pinch cam gear and the pinch lift
cam.
3. Align the hole in the crescent slide !- with the hole in
the mechanism chassis, as shown at point C in Fig. 3-
15-2 (refer to Section 3-16 and see the holes 6 and
7 in Fig. 3-16-1).
4. When fitting the main cam 4, position the OPT pinch
relay gear 6 and the front rack gear != as shown at
points D and E respectively in Fig. 3-15-2.
5. When fitting the gear wheel 2 2, position the main
cam 4 and the wheel gear 1 
