Capstan Motor - Sony SVT-RA40 Service Manual

3-7. Capstan Motor

3-7-1. Capstan Motor
[Case 1. High speed FF/REW model]
1. Refer to Section 3-2, then remove the mechanism unit.
2. Remove the reel belt 1.
3. Remove the three screws 2 and the capstan motor
3.
4. Remove the heat transfer spacer 4 from the capstan
motor 3 or mechanism chassis.
Assembly Notes:
1. Check that connector 5 is inserted in the CP-1 PWB
assembly.
2. When fitting the three screws 2, use the torque gauge
screwdriver (VHJ-0014). Give the screws a tightening
torque of 3.5 kg.cm.
3. After assembly, clean the capstan shaft with a soft
cloth or chamois.
2 Screws
1 Reel belt
Fig. 3-7-1
2-18
[Case 2. Normal FF/REW model]
1. Refer to Section 3-2, then remove the mechanism unit.
2. Remove the screw 1, then remove the capstan
3. Remove the reel belt 3.
4. Remove the three screws 4 and the capstan motor
Assembly Notes:
1. Check that connector 6 is inserted in the CP-1 PWB
2. When fitting the three screws 4, use the torque gauge
3. After assembly, clean the capstan shaft with a soft
4 Heat transfer
spacer
3 Capstan
motor
5 Connector
mounting 2.
5.
assembly.
screwdriver (VHJ-0014). Give the screws a tightening
torque of 3.5 kg.cm.
cloth or chamois.
4 Screws
6 Connector
3 Reel belt
Fig. 3-7-2
5 Capstan
motor
2 Capstan
mounting
1 Screw
SVT-RA40/RA168