Connecting A Pc / Mac Nle System To An Analogue Vcr - Datavideo DAC-200 Installation Manual

Connecting a PC / MAC NLE System to an analogue VCR
Connect the IEEE 1394 / DV Out from your NLE system to the DV In/Out on the
DAC 200. Some NLE systems have 6 Pin DV out, like the DAC 200, while others
use the smaller 4 Pin connection, either type of connection will work OK.
Connect the analogue Audio and video outputs on the rear of the DAC 200 to the
inputs on your record deck. If your record deck has S­Video (Y/C) available it is
advisable to use it in preference to the Composite (Yellow Phono / RCA
connector).
N.B. Please ensure that you set the input of your record deck to the appropriate
setting. Some of the names used by VCR manufacturers are AUX (Auxillary),
Line1, AV1, F1, EXT (External).
Check that the DAC 200 has the DV light on, if it does not press the source
button.
Make sure your DIP switch settings are correct for your set up (see page 11)
13