Table of Contents
Advertisement
PABX access code
If you are connecting your BT Zenith Flip to a switchboard/PBX you may need to enter an
access code (e.g. 9) in order to get an outside line. So that the switchboard has time to
pick up an outside line, you may also need to add a Pause after the access code in
numbers stored in the phonebook, see page 82.
Set PABX access code
1. Select
Menu
and scroll
2. Scroll
UP
or
DOWN
3. Select
OK
and enter the access code you want. Select
4. Select
OK
to confirm or
Switch PABX access code on or off
You may want to do this if using a handset with different bases, one of which is
connected to a switchboard.
When the code is switched off your handset will not dial the code automatically before
each telephone number.
1. Select
Menu
and scroll
2. Scroll
UP
or
DOWN
highlight
On
or
Off
4. Select
OK
to confirm. Then select
If you experience any problems, please call the Helpline on 0870 605 8047
BT Zenith Flip – Issue 1 – Edition 04 – 08.09.05 – 6861
UP/DOWN/LEFT/RIGHT
to
PABX Access Code
Back
to return to the previous screen without saving the code.
UP/DOWN/LEFT/RIGHT
to
PABX Access Code
.
Back
to return to standby.
to
Handset
. Select
and select
OK
.
Set Code
Clear
to delete any incorrect digits.
to
Handset
. Select
and select
OK
then scroll
General information
OK
.
is highlighted.
OK
.
UP
or
DOWN
to
81
Advertisement
Table of Contents
