13
SERVICE WORK ON THE CHASSIS
13.21
Installing the front fender
13.22
Cleaning the dust boots of the fork legs
–
Position the fender.
Info
Pay attention to the routing of the brake lines and the cable.
–
Mount and tighten screws
Guideline
Screw, fender
V00754-11
–
Insert the brake lines and cable in brackets
Preparatory work
–
Raise the vehicle with the center stand. (
–
Remove the front fender. (
Main work
–
Push dust boots
Info
The dust boots should remove dust and coarse dirt particles from the fork
tubes. Over time, dirt can accumulate behind the dust boots. If this dirt is not
removed, the oil seals behind can start to leak.
V00755-10
1
.
2
p. 134)
p. 156)
1
of both fork legs downward.
M5x12
3.5 Nm
(2.58 lbf ft)
and close the holder.
157