22
TROUBLESHOOTING
Faults
The ABS indicator lamp lights up
High oil consumption
The battery is discharged
Possible cause
ABS fuse is blown
Wheel speeds of front and rear wheels
differ greatly
Malfunction in ABS
Engine oil level too high
Engine oil too thin (low viscosity)
A power consumer is connected to the
socket/ACC1.
The hazard warning flasher is switched
on
Battery is not charged by alternator
Ignition was not switched off when
vehicle was parked
Action
–
Change the fuses in the fuse box. (
–
Stop, switch off the ignition, start again.
–
Read out the fault memory using the KTM diag-
nostics tool.
–
Check the engine oil level. (
–
Change the engine oil and oil filter and clean the
oil screens.
(
p. 213)
–
Disconnect the power consumer from the
socket/ACC1.
–
Recharge the battery.
–
Switch off the hazard warning flasher.
–
Recharge the battery.
–
Check the charging voltage.
–
Recharge the battery.
227
p. 200)
p. 212)
(
p. 193)
(
p. 193)
(
p. 193)