Kyocera KM-2550 Service Manual page 97

2FT-1
Maintenance
item No.
Checking toner motor operation
U135
Description
Drives toner motor.
Purpose
To check the operation of toner motor.
Start
1. Press the start key. The screen for selecting an item is displayed.
2. Select the item using the up/down cursor keys.
Display
MOTOR MOVING
ON TIME
Method for toner motor on
1. Press the start key. The operation starts.
2. To stop operation, press the stop/clear key.
Setting for toner motor on time
1. Change the setting using the left/right cursor keys.
Description
Toner motor on time
2. Press the start key. The value is set.
Completion
Press the stop key after operation stops. The screen for selecting a maintenance item No. is displayed.
Setting toner loading operation
U144
Description
Sets toner loading operation after completion of copying.
Purpose
To set whether or not toner is loaded on the drum after low density copying. Normally no change is necessary
from the initial setting.
Method
Press the start key. The screen for selecting an item is displayed.
Setting
1. Select either ON or OFF using the up/down cursor keys. The selected item is displayed in reverse.
Display
ON
OFF
Initial setting: OFF
2. Press the start key. The value is set.
Available only when the mode is turned on.
3. Select the item using the up/down cursor keys.
4. Change the setting using the left/right cursor keys.
Display
COUNT
PERCENT
Example
When COUNT is 5 and PERCENT is 30, take the average in every five sheets, and perform the toner
loading operation when the printing ratio is 3% or less.
5. Press the start key. The value is set.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
1-4-30
Description
Description
Turning the toner motor on
Toner motor on time
Description
Toner loaded
Toner not loaded
Description
Count number of sheets
Printing ratio
Setting range
1 to +10 (s)
Setting range
1 to 50
10 to 40
Initial setting
3
Initial setting
5
30