Kyocera KM-2550 Service Manual page 49

15. Fit the pin located at the left rear side of the
intermediate tray from the rear side of the
MFP onto the hook of the transfer unit.
16. Remove the tape and pull out the 13-pin
connector and 24-pin connector.
17. Connect the 24-pin connector of the inter-
mediate tray to the connector of the transfer
unit.
18. Connect the 13-pin connector of the inter-
mediate tray to YC5 on the engine circuit
board.
Attach the covers.
19. Attach the cover that has been removed by
Procedure 8 to its original position using the
two screws.
20. Attach the large ejection cover with the two
screws that have been removed by Proce-
dure 1.
24-pin connector
13-pin connector
Tape
Figure 1-3-47
YC5
13-pin connector
24-pin connector
Figure 1-3-48
Large ejection cover
Screws
Figure 1-3-49
2FT
Pin
Hook
Connector
1-3-27