Kyocera KM-2550 Service Manual page 26

2FT-1
Install the optional original cover or DP.
1. Install the optional original cover or DP (see pages 1-3-9 to 1-3-12 when installing the DP).
Install the optional duplex unit.
1. Install the optional duplex unit as necessary (see pages 1-3-13 to 1-3-15).
Install the optional finisher or job separator.
1. Install the optional finisher or job separator as necessary (see pages 1-3-22 to 1-3-34).
Install the toner container.
1. Open the front cover.
2. Tap the top of the toner container five to six
times.
3. Shake the toner container approximately 10
times in the horizontal direction to stir toner.
4. Turn the toner container release lever and
gently push the toner container into the
MFP.
*Push the container all the way into the MFP
until it locks in place.
5. Restore the toner container release lever.
6. Close the front cover.
Connect the connector of the drawer heater.
*Connect according to need.
1. Remove the right cover.
2. Connect the connector of the drawer heater
to YC7 of the power source PCB.
3. Refit the right cover.
1-3-4
Toner container release lever
Figure 1-3-4-1
Connector of the drawer heater
Figure 1-3-4-2
Toner container
YC7