Kyocera KM-2550 Service Manual page 27

Connect the power cord.
1. Connect the power cord to the connector on the MFP.
2. Insert the power plug into the wall outlet and turn the power switch on.
Installing the toner (maintenance item U130).
1. Enter the maintenance mode by entering "10871087" using the numeric keys.
2. Enter "130" using the numeric keys and press the start key.
3. Select the"EXECUTE" using the up/down cursor keys
4. Press the start key to execute the maintenance item.
Installation of toner starts and time (minutes) is indicated until the installation ends.
5. When the installation is complete, "FINISHED" will be displayed if the installation is successful or "NG" will be
displayed if it has failed.
If "NG" is displayed, check to see if the toner container contains toner and to see if the toner container sensor
malfunctions and then try again.
6. Press the stop/clear key.
Load paper.
1. Load paper in the drawer.
Output an own-status report (maintenance item U000).
1. Enter "000" using the numeric keys and
press the start key.
2. Select "MAINTENANCE" and press the start
key to output a list of the current settings of
the maintenance items.
3. Press the stop/clear key.
Exit maintenance mode.
1. Enter "001" using the numeric keys and press the start key.
The machine exits the maintenance mode.
Make test copies.
1. Place an original and make test copies.
Set A3/11" x 17" paper on drawer 2 and run the maintenance item U113 (Performing drum refresh operation) if
a faulty image (black lines, etc.) occurs.
End of installation.
2FT-1
1-3-5