Installing The Duplex Unit (Option) - Kyocera KM-2550 Service Manual

1-3-5

Installing the duplex unit (option)

<Procedure>
1. Open the left cover.
2. Remove the stop ring and the strap from the rear side.
3. Restore the conveyor section.
4. Remove the pin and plate, and then remove the stopper from the front side.
5. Open the left cover until it is put horizontally.
6. Turn the wire guide section of the duplex
unit in the direction indicated by the arrow.
7. Insert the axis sections of the duplex unit
into the Ushape grooves of the conveyer
unit.
Stop
ring
Strap
Left cover
Figure 1-3-19
Figure 1-3-20
Axis section
Figure 1-3-21
Plate
Stopper
Pin
Wire guide section
Axis section
Duplex unit
2FT-3.0
1-3-13