1-3 Installation
1-3-1
Unpacking and installation
(1) Installation procedure
Install the optional paper feeder.
Remove the tapes and pins.
Install the optional original cover or DP.
Install the optional duplex unit.
Install the optional finisher or job separator.
Install the toner container.
Connect the connector of the drawer heater.
Start
Unpacking.
Connect the power cord.
Installing the toner
(maintenance item U130).
Load paper.
Output an own-status report
(maintenance item U000).
Exit maintenance mode.
Make test copies.
End of installation.
2FT-1
1-3-1