Internal Usb Memory Key (Optional); Replacing The Optional Internal Usb Memory Key - Dell E30S Series Owner's Manual

Internal USB memory key (optional)

An optional USB memory key installed inside your system can be used as a boot device, security key, or mass storage device.
To boot from the USB memory key, configure the USB memory key with a boot image and then specify the USB memory key in
the boot sequence in System Setup.
The internal USB port must be enabled in Internal USB Port option in the Integrated Devices screen of System Setup.
To locate the internal USB port (INT_USB) on the system board, see the System board jumpers and connectors
NOTE:
section.

Replacing the optional internal USB memory key

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
Steps
1. Locate the USB connector or USB memory key on the system board.
To locate the internal USB connector on the system board, see the System board connectors section.
NOTE:
2. If installed, remove the USB memory key from the USB connector.
3. Insert the replacement USB memory key into the USB connector.
Figure 60. Removing the internal USB memory key
a. USB memory key
b. USB port
120 Installing and removing system components