Dell E30S Series Owner's Manual page 169

Figure 113. Installing the screws on the system board
a. screws (9)
Next steps
1. Install the Trusted Platform Module (TPM). For information on how to install TPM, see Installing the Trusted Platform
Module section. For information on TPM, see the Trusted platform module section.
2. Replace the following:
a. processors(s) and heat sink(s)
b. internal USB key (if required)
c. internal dual SD module
d. cooling shroud
e. internal cooling fan
f. expansion cards
g. expansion card holder
h. iDRAC ports card
3. Reconnect all cables to the system board.
Ensure that the cables inside the system are routed along the chassis wall and secured using the cable securing
NOTE:
bracket.
4. Follow the procedure listed in the After working inside your system section.
5. Ensure that you:
a. Use the Easy Restore feature to restore the service tag. For more information, see the Easy restore section.
b. If the service tag is not backed up in the backup flash device, enter the system service tag manually. For more
information, see the Entering the system service tag section.
c. Update the BIOS and iDRAC versions.
d. Re-enable the Trusted Platform Module (TPM). For more information, see the Re-enabling the TPM for BitLocker users
section or Re-enabling the TPM for TXT users section.
Installing and removing system components 169