Dell E30S Series Owner's Manual page 138

WARNING: The processor will be hot to touch for some time after the system has been powered down. Allow the
processor to cool before removing it.
CAUTION: The processor is held in its socket under strong pressure. Be aware that the release lever can spring
up suddenly if not firmly held.
Steps
1. Release the socket lever by pushing the lever down and out from under the tab on the processor shield.
2. Lift the lever upward until the processor shield lifts.
CAUTION: The processor socket pins are fragile and can be permanently damaged. Be careful not to bend the
pins in the processor socket when removing the processor out of the socket.
3. Lift the processor out of the socket.
After removing the processor, place it in an antistatic container for reuse, return, or temporary storage. Do
NOTE:
not touch the bottom of the processor to avoid damage to the processor contacts. Touch only the side edges of the
processor.
Figure 79. Removing a processor
1. close first socket-release lever
3. processor
5. processor shield
7. socket
Next steps
1. Install the processor.
2. Install the heat sink.
3. Follow the procedure listed in the After working inside your system section.
138 Installing and removing system components
2. pin-1 indicator of processor
4. slot (4)
6. open first socket-release lever
8. socket keys (4)