Control Panel Assembly; Removing The Control Panel Assembly - Dell E30S Series Owner's Manual

Control panel assembly

Removing the control panel assembly

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Keep the Phillips #2 screwdriver ready.
3. Follow the procedure listed in the Before working inside your system section.
Steps
1. Remove the screw securing the control panel to the chassis.
2. Disconnect the control panel cable and the control panel USB cable from the system board.
CAUTION: Do not use excessive force when removing the control panel cables as it can damage the
connectors.
3. Slide the control panel out of the chassis.
4. Disconnect the control panel cable and the control panel USB cable from the control panel.
Figure 95. Removing the control panel assembly
1. control panel
3. control panel USB cable
5. Locate and press the tabs on the information tag.
6. Push the information tag out of the slot to remove it from the control panel.
Retain the information tag to replace it in the new control panel.
NOTE:
154 Installing and removing system components
2. control panel cable
4. screw