Correctly Using The Embroidery Frames - Brother 884-T23 Operation Manual

 The embroidery frame holder is ready for the
embroidery frame to be attached.
c Hold the embroidery frame level, and then
simultaneously align both the left and right mounts
with the embroidery frame holder clips.
• The inner frame should be on top.
d Insert the embroidery frame until it snaps into place.
1 Make sure that the pins on the left and right arms of the
embroidery frame holder fit into the positioning slot and
hole on the embroidery frame.

Correctly using the embroidery frames

The various types of embroidery frames and their uses are
described below.
In addition to the included embroidery frames, there are many
frames that can be used with this machine. (Refer to "Optional
accessories" on page 14.)
CAUTION
• Only use embroidery frames of the sizes
indicated in the screen, otherwise the
embroidery frame may hit the presser foot,
which may result in injuries.
■ Embroidery frame holders
Two types of embroidery frame holders (embroidery frame
holder A and embroidery frame holder B) are included
with this machine.
Embroidery frame holder A is used with the four included
embroidery frames and the optional 300 mm (W) × 200
mm (H) (11-3/4 inches (W) × 7-7/8 inches (H)) Flat frame.
Embroidery frame holder B is used with the optional
embroidery frames. In addition, if you purchase optional
round frame set, clamp frame set, compact frame set or
versatile magnetic frame kit, specified frame holder C, D,
E or F is included. For details on which embroidery frame
can be installed on each embroidery frame holder, refer to
"Types of embroidery frames/frame holders and their
applications" on page 68.
j
1 Embroidery frame holder A
2 White corner covers
3 Embroidery frame holder B
4 Light gray corner covers
5 Magnet
6 Embroidery frame holder C (optional)
7 Dark gray corner covers
8 Embroidery frame holder D (optional)
9 Embroidery frame holder E (optional)
0 Embroidery frame holder F (optional)
■ When difficult to replace the embroidery
frame
Depending on the position of the needle bars, it may be
difficult to replace the embroidery frame. In that case,
follow the procedure described below to move the
embroidery frame.
a Touch .
 The needle bar move screen appears.
b Touch .
 The carriage automatically moves to a position
where the embroidery frame can easily be replaced.
• Touch to close the needle bar move screen
and to move the carriage to the previous position.
BASIC EMBROIDERY
67
2