Step 2: Installing the Software
Important: Always close any open programs and turn off Anti-virus utilities
before installing software.
PC:
1. Turn on your computer.
2. Place the Microtek Software CD/DVD
3. Follow the on-screen instructions to
4. Click EXIT on the Microtek Software Installer screen when all the software
5. Restart your computer.
MAC:
1. Turn on your computer.
2. Place the Microtek Software CD/DVD into a drive, and double-click the
3. Install the remaining software components, then restart your computer at the
Drivers & Software Upgrades
After you finish the installation of software, if you found that the installed drivers and software
cannot run your product or your computer system properly later, please go to the Microtek
Download Service site at ww7.microtek.com.tw/service.php to download and install any updates
you may require.
For additional information about Microtek products, please visit our website at www.microtek.com.
14
ArtixScan DI 5240/5250/5260 User's Manual
into a drive.
install the driver and software.
NOTE: If the Microtek Software
Installer screen does not come up
automatically, double-click the following
in succession: "My Computer"; the CD-
ROM (or DVD-ROM) icon; then cdsetup.
exe to start the installer program.
has been installed.
ScanPotter installer icon to install ScanPotter.
end of all software installation.
NOTE: After rebooting your Macintosh, the Microtek software will attempt
to locate your scanner on the system. Since this is your first install and you
have not yet connected the scanner, simply ignore the message that appears
and proceed to the next step.