Table of Contents
Advertisement
3. The Separation Module consists of two parts: 1) Retard Pad Assembly, and
2) Retard Roller Assembly, as indicated in the graphic.
To replace the old Retard Pad with a
new pad,
a)
Press the two tabs at the top
of the module downward with
your fingers.
b)
Hold the two arms of the
module and pull the old Retard
Pad off from its compartment.
c)
Replace the Retard Pad with
new one and install it back into
its compartment until you hear
a "click".
4. Hold the two sides of the new Separation Module Assembly and install it
back into its compartment until it snaps into place. Finally, push the ADF
cover back down into place until you hear a "click".
NOTE:
•
The recommended replacement point for the Separation Module Assembly is
approximately 100,000 scans through the feeder.
•
Please contact your local resellers for purchasing new Separation Module
Assembly.
Retard Roller
Assembly
Retard Pad
Assembly
ArtixScan DI 5240/5250/5260 User's Manual
53
Advertisement
Table of Contents
