Web Configuration - Crestron TS-770 Product Manual

Web Configuration

The touch screen may be monitored and configured using the included web configuration
interface. The configuration interface is accessible from a web browser if the touch screen IP
address is known. This interface is also accessible using the XiO Cloud® service.
To access the configuration interface:
1. Use the Device Discovery tool in Crestron Toolbox™ software to discover the touch screen
and its IP address on the network.
2. Open a web browser.
3. Enter the touch screen IP address into the browser URL field. The configuration interface
is displayed (TS-1070 shown).
NOTE: If authentication is enabled for the touch screen, an administrator username and
password must be entered prior to accessing the web configuration interface. For more
information on configuring authentication settings, refer to
Web Configuration Interface
The configuration interface provides the following tabs:
Status: Used to monitor touch screen status
l
Settings: Used to configure touch screen settings
l
Security: Used to enable authentication and other security settings
l
802.1x Configuration: Used to configure IEEE 802.1x network authentication for touch
l
screen security
36 • TS-770 and TS-1070
Authentication (on page 61).
Product Manual — Doc. 8555D