Table of Contents
Advertisement
6. Remove the camera.
7. Remove the
display
panel.
8. Remove the
display
hinges.
9. Remove the
display
cable.
Procedure
NOTE:
This procedure is applicable only for computers shipped with non-touchscreen displays.
After performing all the above steps, we are left with the display back-cover and antenna assembly.
Replacing the display back-cover and antenna assembly
NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in
Before working inside your
working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Procedure
NOTE:
This procedure is applicable only for computers shipped with non-touchscreen displays.
Place the display back-cover and antenna assembly on a clean and flat surface.
computer. After working inside your computer, follow the instructions in
Removing and installing components
After
73
Advertisement
Table of Contents
