Connect The Waterborne Fluid Hose - Graco 333013B Instructions - Parts Manual

Installation
Connect the Waterborne Fluid
Hose
NOTE: The Graco warranty is void if the spray gun is
connected to a non-Graco voltage isolation system or if
the gun is operated above 60 kV.
Always use a Graco Waterborne Fluid Hose between
the voltage isolation system fluid outlet and the gun fluid
inlet.
Before connecting the Waterborne Fluid Hose to the
gun, blow it out with air and flush with water to remove
contaminants. Flush the gun before using it. See Flush-
ing, page 26.
To reduce the risk of electric shock, install only one
continuous Graco Waterborne Fluid Hose between
the isolated fluid supply and the spray gun. Do not
splice hoses together.
1. Remove the air cap (25), spray tip (3), and shroud
(26).
2. Ensure the barrel fluid inlet is clean and dry. Apply
dielectric grease to the threads of the barrel connec-
tor (600a) and screw it in to the fluid inlet.
3. Apply dielectric grease to the threads of the hose
(600) and screw it in to the barrel connector (600a).
4. Secure hose in strain relief bracket by tightening the
four plastic screws.
Strain Relief Bracket
F

. 6 Connect the Waterborne Fluid Hose

IG
16
To reduce the risk of electric shock, the areas of the
Graco Waterborne Fluid Hose that are accessible to
personnel during normal operation must be covered
by the black outer hose jacket.
5. Connect the other end of the fluid hose to the iso-
lated fluid supply as follows:
a. Graco WB3000 Enclosure: Slide the other end
of the hose through the hole in the side of the
isolated enclosure. Connect the swivel (Z) to the
fluid outlet of the pump. Secure the hose to the
side of the enclosure with the bracket (W).
b. Non-Graco Isolated Enclosure: Connect hose
as instructed in the isolation system manual.
6. Reinstall the shroud (26), spray tip (3), and air cap
(25).
7. Check the gun's electrical grounding (see page 19).
F . 7 . Unshielded Hose 24W599 Connection at
IG
WB3000 Enclosure
333013B