Aef Fine Finish Pre-Orifice Spray Tips - Graco 333013B Instructions - Parts Manual

Spray Tip Selection Chart

AEF Fine Finish Pre-Orifice Spray Tips

Recommended for high finish quality applications at low and medium pressures. AEF tips have a pre-orifice that
assists in atomizing sheer thinning materials, including lacquers.
Order desired tip, Part No. AEFxxx, where xxx = 3-digit number from the matrix below
Fluid Output
fl oz/min (l/min)
at 600 psi
Orifice
Size in. (4.1 MPa,
(mm) 41 bar)
0.008 8.5
(0.203) (.025)
0.010 9.5
(0.254) (0.28)
0.0012 12.0
(0.305) (0.35)
0.014 16.0
(0.356) (0.47)
0.016 20.0
(0.406) (0.59)
* Tips are tested in water.
Fluid output (Q) at other pressures (P) can be calculated by this formula: Q = (0.041) (QT)
output (fl oz/min) at 600 psi from the above table for the selected orifice size.
60
6-8
at 1000 psi
(150 - 200)
(7.0 MPa, 70
bar)
11.0
(0.32)
12.5 310
(0.37)
16.0 312
(0.47)
21.0 314
(0.62)
26.5
(0.78)
Maximum Pattern Width at 12 in. (305 mm)
in. (mm)
8-10 10-12
(200 - 250) (250 - 300)
Spray Tip
608
410 510
412 512
414 514
416 516
.
12-14 14-16
(300 - 350) (350 - 400)
610 710
612 712
614 714
616 716
where QT = fluid
16-18
(400 - 450)
812
814
333013B