Installation Of The Product - Husqvarna AUTOMOWER EPOS Operator's Manual

>1.5 m / 5 ft
3.5.3 To examine where to install the Virtual
guide
Virtual guide in a line at a
• Install the
minimum of 2 m / 7 ft. in front of the charging
station.
• Make as much free area as possible to the
Virtual guide when facing the
left of the
charging station. Refer to
to put the charging station on page 18 .
Virtual guide minimum 30 cm / 12
• Install the
in. from the Virtual boundary .
• Do not make sharp bends when you install
Virtual guide .
the
• If the work area has a slope, install the
Virtual guide diagonally across the slope.
22 - Installation
A
>40 cm / 16"
>2 m / 6.5 ft
To examine where

3.6 Installation of the product

3.6.1 General steps for installation of the
product
For full instructions follow the installation
instructions in Installation of the product on page
22 .
1. Install the charging station.
2. Install the reference station.
3. Install the Automower
mobile device.
4. Pair the product with the Automower
Connect app. Do the basic settings in the
start up sequence in the Automower
Connect app.
5. Restart the product to enable pairing mode.
6. Pair the product with the EPOS app.
Site with Work area , Charging
7. Make a
station , Virtual guides and Stay-out zones in
the EPOS app.
Site .
8. Activate the
®
9. Use Automower Connect app to do
settings for the product.
3.6.2 Installation tools
• Mobile device with EPOS app installed.
Included in carton.
• Screwdriver, Torx 20.
• Hex key, 4 mm.
• Hex key, 8 mm. Included in the carton.
• Hex key, 5 mm.
Note: The EPOS app must be used with the
supplied mobile device.
3.6.3 Installation of the charging station
Read and understand the instructions about the
charging station. Refer to
put the charging station on page 18 .
WARNING: Obey national regulations
about electrical safety.
WARNING: The product is only to be
used with the power supply unit
supplied by Husqvarna.
®
Connect app to your
®
®
To examine where to
1460 - 002 - 06.04.2020