Information Messages - Husqvarna AUTOMOWER EPOS Operator's Manual

6.3 Information messages

The information messages in the table below are shown in the
Connect app. Speak to your Husqvarna representative if the same message shows frequently.
Message Cause
Low battery
The product cannot find the charging
station.
The battery is spent.
The charging station's antenna is de-
fective.
Settings restored Confirmation that a
tings has been carried out.
Limited cutting
The cutting height adjustment cannot
height
move.
Unexpected cut-
ting height adj
Limited cutting
height range
Cutting height
problem
Cutting height
blocked
Cutting system im-
The product has discovered vibrations
balance
in the cutting disc.
Slope too steep
The product stopped because the slope
is too steep.
52 - Troubleshooting
Messages menu in the Automower
Action
Change the position of the
guide . Refer to To examine where to in-
stall the Virtual guide on page 22 .
Make sure that the installation settings
about how to find the charging station
is correct. Refer to
station on page 34 .
Replace the battery. Refer to
on page 44 .
Check if the indicator lamp in the
charging station flashes red. Refer to
LED indicator lamp on the charging sta-
tion on page 54 . This problem re-
quires action by authorized service
technician.
Reset all user set- This is normal. No action required.
Examine the cutting height adjustment
and remove grass or other objects. If
the problem stays, speak to your ap-
proved servicing dealer.
Verify that the blades and screws are
intact and not worn out. Verify that all
blades are correctly mounted. Check
that no double blades are mounted on
any of the three blade positions.
Change the installation of the
area to not include this steep part of the
work area. Refer to
boundary in a slope on page 21 .
®
Virtual
To find the charging
Battery
Work
To install the Virtual
1460 - 002 - 06.04.2020