CAUTION: Do not install the
reference station on a flagpole.
Movements of the reference
station will affect the correction
data sent to the product with the
accurate position.
•
Example A shows the best installation of the
reference station. It is installed high with free
view to the sky.
•
Example B shows a good installation of the
reference station. It is installed at a distance
to buildings and trees and have free of view
to the sky in more than 120°.
•
Example C shows a bad installation of the
reference station. It is installed too near
trees and buildings with limited view to the
sky.
A
B
>120°
C
•
Install the reference station minimum 1.5 m /
4.9 ft. from large objects that can block the
18 - Installation
signals from the reference station.
Recommended distance is 3 m / 10 ft.
•
Install the reference station where the radio
signal reaches all parts of the work area.
•
It is recommended to have free line of sight
between product and reference station for
optimal performance.
•
The maximum distance between the
reference station and the product is 250 m /
820 ft. when free line of view. Objects
between the reference station and product
decreases the distance.
•
Install the reference station within reach of a
power outlet.
Note: The low-voltage cable is 20 m / 65 ft.
3.5 To examine where to put the
charging station
Note: Do not install a mower house that will
cause a blockage to the GPS signals.
•
Put the charging station in free line of view
with the reference station.
•
Put the charging station in an open position
with free view to the sky.
•
Keep a minimum 3 m / 10 ft. of free space in
front of the charging station. Refer to
examine where to install the Virtual guide on
page 22 .
•
Keep a minimum of 1.5 m / 5 ft. of free
space to the right and left of the center of
the charging station.
•
Put the charging station near a power outlet.
•
Put the charging station on a level surface.
•
The baseplate of the charging station must
not be bent.
max. 5 cm / 2"
max. 5 cm / 2"
To
1460 - 002 - 06.04.2020