Table of Contents
Advertisement
Installing the frame
Easy four stage process, which will be the same regardless of frame type, for example 3-sided
frame, 4-sided frame, or the 700 masonry frame.
U-shaped fixings (1 of 3) for
screwing the frame in place
CAT5 connection
Room thermistor position in engine
1. Position the frame assembly in front of the engine and connect the CAT5 cable to the frame.
This connects the push button control panel to the engine's box.
2. Route the room temperature thermistor through the grommet located on the LHS of the frame.
The thermistor must protrude by approximately 15 mm as shown above.
3. Slide the two top frame hangers into the corresponding frame slots on the Ember engine and
push the lower section into the recess of the engine.
4. Secure the top section in place, using the screws provided, via the three U-shaped fixing
positions on the frame.
5. Secure the lower section of the frame in place using the two bottom side screws.
Frame hanger (1 of 2)
Frame slots
Lower screw position
Room thermistor position through grommet in
frame, must protrude by approx. 15 mm
Ember Installation Guide: 12890-F 06-21 | 27
Advertisement
Table of Contents
