Table of Contents
Advertisement
Ember mock chimney installation overview
Modify the enclosure
1
Ensure the enclosure meets the requirements set out on p. 9.
Gas and electrical connections
2
Prepare gas and electrical connections, refer p. 8.
Install the zero clearance frame
3
Install the zero clearance frame into the enclosure and fix in place with the screws provided.
This frame is critical and must be installed as it automatically gives the required clearances
to combustibles. Refer p. 18, and frame kit installation instructions.
Flue system installed
4
Install the coaxial* to colinear adaptor. Ensure it is self supported with the frame and
screwed in place. Attach the intake and exhaust flexi flues to the adaptor, clamp and screw
into place—check clearances are maintained. Add colinear sections as required, these twist
and lock into place.
Attach flexi flues to the flue spigot plate
5
Undo the two front screws holding the flue spigot in place and attach the flexi to the spigot
using the clamps provided and screw into place, refer p. 19.
Attach the flue spigot back onto the engine
6
Line up the spigot plate with the flue guide rails on top of the unit, slide the unit into place,
and secure the spigot—two front screws.
Secure Ember to the zero clearance frame
7
Secure engine to the zero clearance frame—nine screw positions (three LHS, three top, and
three RHS).
Complete the gas connection
8
Make the gas connection.
Install the burn media and commission
9
Install the glass, granules, rockwool, logs or stones. Refit the combustion chamber glass
and commission, refer p. 20-26.
Install the frame
10
Install the frame, refer p. 27.
* Can't be more than 600 mm maximum due to the heat from the colinear flexi flues.
16 | Ember Installation Guide: 12890-F 06-21
Advertisement
Table of Contents
