Install The Inner And Outer Frame - Rinnai Evolve 952 Series Installation Manual

Install the inner and outer frames
Installing the outer frame
1. Remove, but don't discard, the two black screws installed in the lower bracket of the heater engine.
2. Position the outer frame close to the heater engine and connect the RJ45 plug into the socket on
the inside top left of the heater. This connects the push button control panel via a communications
cable to the engine control box.
3. Mount the outer frame to the heater by hooking the top over the two tabs on the top lip of the
engine body, then push in until the frame sits flush with the wall. Secure with the two black retaining
screws removed in step 1.
Black screw in lower
bracket
Installing the optional mesh guard and inner frame
The optional mesh guard, if purchased, needs to be installed before the inner frame as the inner
frame holds it in place.
1. Insert the bottom of the mesh guard into the magnet slots and secure in place using the
latches.
2. Mount the inner frame to the engine by hooking the tabs on the inside to the top lip of the
combustion chamber.
3. Rotate the bottom of the inner frame in towards the engine body allowing the magnets to
secure the inner frame to the engine.
Two latches are
positioned either
side, at the top of
the engine
Magnets
RJ45 plug inside
top left of heater
Top and side view of tab on top lip of engine
body
Top of combustion chamber
Inner frame tabs
f
Magnet
slot
Inner frame
Evolve 952/1252 Installation Guide: 13115-E 05-19 | 25
Outer frame
mounted on tabs