Table of Contents
Advertisement
Step 1: Back log
Place the back log onto the two log location brackets at the back of the burner. The charred side
faces to the front.
Step 2: Adding the granules and rockwool
Place, DO NOT POUR, the granules, ensuring even coverage around the burner ports (so as not
to cause blockages). For the 700 you will need both granule packs, for the 600 it's about a bag and
three quarters. Pinch and roll the rockwool into pea-sized balls (600 ≈ 35, 700 ≈ 50) and place in-
between the granules. These can go over the burner ports as the material is designed for the flame
to penetrate through the ceramic fibres to enhance the flame picture and produce a glow effect.
Step 3: Front log
Add the front log onto the two log locating pins inside the grill. It should sit securely into the gap.
Step 4: Top three logs
Add the three top logs onto the locating pins of the back and front logs—refer photos on previous
page. Underneath each log is a hole (front position) and a slot (back position).
Ember Installation Guide: 12890-F 06-21 | 23
Advertisement
Table of Contents
