Removing The Burner Box Glass Panel; Adding The Glass And Vermiculite - Rinnai Ember 600 Installation Manual

Removing the burner box glass panel

Before adding the burn media, the burner box glass panel needs to be
removed. There are two screws on each side (circled on the image to the
right). DO NOT undo the screws holding the metal L brackets in place, as
these hold the glass in place.
When replacing the glass panel, the join in the rope seal MUST BE at the
bottom.

Adding the glass and vermiculite

This step is common to both models and types of burn media. It requires removing the upper burn
media tray to access the mesh holding tray.
1. Unscrew the left and right tray screws to lift off the upper mesh holding tray.
2. Carefully empty the bags of vermiculite and glass into the mesh tray, blend together and level
out.
3. Put the upper tray back in place and re-tighten the screws.
1
2
2
Ember Installation Guide: 12890-F 06-21 | 21