Responding To Error Messages - Canon imageCLASS 2300 Printer Manual

Responding to Error Messages

If printing is disabled during a print job for some reason, the Alarm indicator will
light up and an error message(s) will appear on the display. In addition, for any
phenomenon that does not affect printing function of the printer but requires some
measure to be taken, a warning message will appear on the display. When any of
these messages appear on the display, follow one of the remedies listed to respond
to the message.
NOTE
•
When two or more problems that are indicated by warning messages occur
4
simultaneously, the corresponding messages will appear alternately.
•
When two or more error messages appear on the display simultaneously, warning
messages will not appear there.
•
For messages attached with <Error Skip>, the printer will be able to continue printing by
"skipping errors" when you press [OK]. It should be remembered, however, that some
pieces of print data may be omitted or may not be printed correctly. If you want to stop the
procedure, perform a software reset and remove the cause. Then press [OK] to start
printing again.
E001 ERROR CALL FOR SERVICE
Cause
Remedy
E100-ERROR CALL FOR SERVICE
Cause
Remedy
E805-ERROR CALL FOR SERVICE
Cause
Remedy
4-8

Responding to Error Messages

A fuser overheating error.
Turn the printer OFF, wait 15 minutes and then turn the printer back ON. If this
error persists, turn the printer OFF, unplug power cord from the AC outlet and
contact your service representative.
A scanner motor or laser unit error.
If this error persists, contact your service representative.
A fan failure error.
Turn the printer OFF, wait 15 minutes and then turn the printer back ON. If this
error persists, turn the printer OFF, unplug power cord from the AC outlet and
contact your service representative.