Table of Contents
Advertisement
Using Group Dialling
To send a fax to a group, follow these instructions.
1.
Prepare the document, load it into the Automatic Document Feeder
(ADF), and adjust the resolution as described in "Loading the
Document" on page 4-5.
2.
Use the one-touch speed dialling buttons and/or the CODED DIAL
button (along with the two-digit codes) to select the groups
registered under those buttons and/or codes.
N
You can make up to 55 groups.
If you press a one-touch speed dialling button or coded speed
dialling code that has no group (or fax number) registered under it,
the LCD displays NO TEL #. Make sure you pressed the correct one-
touch speed dialling button or entered the correct coded speed
dialling code, and that the group you want has been registered
correctly under that button or code.
After entering a one-touch speed-dialling button or coded speed
dialling code, you have five or ten seconds to press each subsequent
speed-dialling button or code before the MultiPASS C20 begins
sending.
3.
When you finish entering groups, press START/COPY.
3-32
Sending and Receiving Faxes
If you make a mistake when selecting a group, press the
(STOP) button and start again.
The MultiPASS C20 then scans the document into memory, and
begins dialling the numbers in the groups.
Chapter 3
Advertisement
Table of Contents
