General Problems - Canon Color imageCLASS MF8170c Basic Manual

General Problems

The machine has no power.
Q
A
Nothing appears in the LCD.
Q
A
9
Q
A
9-36 General Problems
Is the power cord plugged in securely?
Check that the power cord is plugged securely into the machine and into the
wall outlet. Insert the power cord straight into the power socket on the back of
the machine. Do not insert it at an angle. Otherwise, the machine may not be
properly connected to the power source and may not turn on. If this happens,
disconnect the power cord, and reconnect it correctly after a minute or more.
(See the Set-Up Instructions for the Machine.)
Is the power cord plugged in securely?
Check that the power cord is plugged securely into the machine and into the
wall outlet. Insert the power cord straight into the power socket on the back of
the machine. Do not insert it at an angle. Otherwise, the machine may not be
properly connected to the power source and may not turn on. If this happens,
disconnect the power cord, and reconnect it correctly after a minute or more.
(See the Set-Up Instructions for the Machine.) If the LCD remains blank, unplug
the machine and wait approximately 3 minutes to 5 minutes until the
temperature inside the machine lowers, then plug it in again. If the LCD remains
blank, unplug the machine, and contact Canon Authorized Service Facilities or
the Canon Customer Care Center.
Does the Energy Saver key go off?
When the Energy Saver key lights up, the energy saver mode activates. To
restore the machine from the energy saver mode, press [Energy Saver].