Canon imageCLASS MF4150 Advanced Manual page 53

Advanced Fax
1
Features
Cannot receive a fax automatically.
Advanced Copy
Features 2
System Monitor
3
Reports and Lists
4
Troubleshooting
5
Appendix
6
Table of Contents
Index
Q Is the machine set to receive automatically?
A For the machine to receive faxes automatically,
receive mode must be set to <FaxOnly>,
<AnsMode>, <DRPD> or <FAX/TEL>. If you have
set <AnsMode>, confirm that an answering
machine is connected to the machine and that it is
turned on with an outgoing message properly
recorded. (See "Setting the Receive Mode," on
p. 1-8.)
Q Is a document stored in memory, leaving little
or no memory available?
A Print, send, or delete any documents stored in
memory.
Q Has an error occurred during reception?
A Check the LCD for an error message. (See
Chapter 11, "Troubleshooting," in the Basic Guide.)
A Print an Activity Report and check for an error.
(See "ACTIVITY REPORT," on p. 4-5.)
Back
Q Is paper loaded in the machine?
A Make sure paper is loaded in the machine. (See
"Set Up the Paper Cassette and Load Paper," in the
Starter Guide.)
Q Is the telephone cable connected properly?
A Make sure the cable is connected properly. (See
"Connect Telephone Cables," in the Starter Guide.)
Cannot receive a fax on both sides of the paper
Q Is the two-sided printing switch set to 'ON'?
A Make sure that the two-sided printing switch is set
to 'ON'. (See "Two-Sided Printing," on p. 1-14.)
TOP
Previous Next
5-10