Receiving Problems - Canon imageCLASS MF4150 Advanced Manual

Advanced Fax
1
Features
Errors occur frequently while sending.
Advanced Copy
Features 2
System Monitor
3
Reports and Lists Cannot redial with [Redial/Pause].
4
Troubleshooting
5
Appendix
6
Entering the fax number is required again after pressing [Start].
Table of Contents
Index
Q Are the telephone lines in poor condition, or do
you have a bad connection?
A Check if there is a device nearby that interferes
with signal transmission (e.g., microwave oven).
Q Is <RESTRICT REDIAL> set to <ON> in the <TX
SETTINGS> of the <FAX SETTINGS> menu?
A When <RESTRICT REDIAL> is set to <ON> in the
<TX SETTINGS> of the <FAX SETTINGS> menu,
Redialing is not available. (See Chapter 12,
"Machine Settings," in the Basic Guide.)
Q Is <CONFIRM NEW DEST.> set to <ON> in the
<TX SETTINGS> of the <FAX SETTINGS>
menu?
A If <CONFIRM NEW DEST.> is set to <ON> in the
<TX SETTINGS> of the <FAX SETTINGS> menu,
you need to enter the fax number again after
pressing [Start]. (See Chapter 12, "Machine
Settings," in the Basic Guide.)
Back
■

Receiving Problems

Part of the documents you receive are cut off.
Q Are the slide guides in your multi-purpose tray
set to the size of the paper?
A Adjust the guides of the multi-purpose tray to the
size of the paper.
Q Have you specified the correct paper size for
the multi-purpose tray?
A Specify the correct paper size for the multi-purpose
tray.
Q Is the printing method for received documents
set to <CUT>?
A If you want to print a received document without
cutting off the end, set the printing method to <ON>
or <OFF>. (See "Reducing Received Images," on
p. 1-13.)
TOP
Previous Next
5-9