Brother HL-2400Ce Series User Manual page 138

USER'S GUIDE
Selected Mode
RESET PRINTER
RESET SETTING 1-2
FACTORY SETTINGS
LCD Message
FC ROLLER
OPC BELT
FUSER UNIT
120K KIT
4–74
4. Press the Set button to make the displayed selection effective.
The printer is reset according to the selected reset mode.
1* - # indicates the selected number of saved settings
The printer automatically exits from the reset mode to the on-
line state.
5. When you enter the RESET PARTS LIFE mode:
The reset item is selected according to the Maintenance message that
shows the currently recommended part to replace. Press Set to reset
the parts life. See Chapter 5 for more detailed information.
List of Factory Settings
The following table shows the factory settings made before shipment.
Notes
The settings are subject to the emulation mode. Effective modes are
indicated in parentheses in the following table.
The following settings cannot be restored to the factory settings with
the Reset button in the "FACTORY SETTINGS" mode:
INTERFACE MODE, HRC SETTING, PAGE PROTECTION,
SCALABLE FONT, LOCK PANEL, PAGE COUNTER and local
LANGUAGE for display messages.
The COPY setting is always restored to the factory setting when the
printer is turned off and on again.
The user settings are overwritten after resetting to User Settings 1 or
2.
LCD message
08 RESET TO USER SETTINGS
08 RESET TO SETTING # 1*
09 RESET TO FACTORY
SETTINGS
Parts replaced
Fuser Cleaner
(OPC) Belt Cartridge
Fixing Unit
Drum Cleaner, Paper Discharge,
Transfer Roller