Panel Installation - Carrier Super-Slim 18-24 Installation Manual

Panel Installation

CAUTION
DO NOT place the panel facedown on the floor,
against a wall, or on uneven surfaces.
(A)
Super-Slim models
Step 1: Remove the front grille.
1. Push both of the tabs towards the middle
simultaneously to unlock the hook on the grille.
2. Hold the grille at a 45° angle, lift it up slightly and
detach it from the main body.
Step 2: Remove the installation covers at the
four corners by sliding them outwards.
Step 3: Install the panel
Align the front panel to the main body, taking into
account the position of the piping and drain sides.
Hang the four latches of the decorative panel to the
hooks of the indoor unit. Tighten the panel hook
screws evenly at the four corners.
Page 27-GB
NOTE: Tighten the screws until the thickness
of the sponge between the main body and the
panel reduces to 4-6mm (0.2-0.3"). The edge of
the panel should be in contact with the ceiling
well.
Adjust the panel by turning it to the arrowed
direction so that the ceiling opening is completely
covered.
Latch
Piping side
Drain side
Screwdriver
1. Connect the two louver motor connectors to the
corresponding wires in the control box.
Control box
Connect the
louver motor
Connect the
louver motor