Panel Installation - Carrier 45MBCAQ Installation Instructions Manual

45MBCAQ: Installation Instructions
CAUTION
• While connecting the wires, please strictly follow the wiring
diagram.
• The refrigerant circuit can become very hot. Keep the
interconnection cable away from the copper tube.
5. Clamp down the cable with the cable clamp. The cable must not be
loose or pull on the u-lugs.
6. Reattach the electric box cover.

PANEL INSTALLATION

CAUTION
DO NOT place the panel facedown on the floor, against a wall, or on
uneven surfaces.
Step 1: Remove the front grille.
1. Push both of the tabs towards the middle simultaneously to unlock the
hook on the grille.
Fig. 31 —Unlock Hooks and Grill
2. Hold the grille at a 45° angle, lift it up slightly and detach it from the
main body.
Fig. 32 —Detach Grill from Body
Step 2: The panel hook is pre-hung to the indoor unit flow guide ring,
as shown.
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
Fig. 33 —Panel Hook
Step 3: Install the panel with four screws (M5), as shown.
Fig. 34 —Install Panel
NOTE: If the height of the indoor unit needs to be adjusted, you can do so
through the openings at the panel's four corners. Make sure that the
internal wiring and drainpipe are not affected by this adjustment.
Water condensation
Fig. 35 —Adjust Height of Indoor Unit
CAUTION
Failure to tighten screws can cause water leakage.
Gap not allowed
Fig. 36 —Tighten Screws to Avoid Water Leakage
23
1
Loosen upper nut
2
Adjust lower nut