Maintenance - Panasonic ER-GC71 Operating Instructions Manual

Trimming the downy hair
Without comb attachment
Holding the clipper with the power
switch facing outwards, trim by
bringing the blade in contact with
the skin.
• The clipper cannot trim hair to
lengths less than 0.5 mm.

Maintenance

• Clean the clipper and the blade after each use.
(If not cleaned, the motion will become poor and the
sharpness will worsen.)
• Make sure that the clipper is turned off.
• Remove the clipper from the AC adaptor.
• Do not use thinner, benzine, alcohol or other
chemicals. Doing so may cause failure, cracking or
discoloration of the main body. Clean the main body
only with a soft cloth slightly dampened with tap water
or soapy tap water.
PB017706 - ER-GC63 53 _(01GB)_04-25-19.indd 15
Cleaning with water
Main body, blade and comb attachment
To remove light dirt
1. Remove the comb
attachment and turn
the clipper on.
2. Run water down the
water inlet at the front
of the main body, rinse
thoroughly for
approximately 20
seconds, and then turn
the clipper off.
• Shake up and down several times to remove the
water.
• Be careful not to hit the main body on the sink or
any other object while draining the water. Failure
to do so may cause malfunction.
To remove heavy dirt
1. Remove the comb
attachment and blade.
2. Clean the clipper, the
blade and the comb
attachments with
running water.
15
2019/4/25 15:04:15