Panasonic ER-GC70 Operating Instructions

Ref.No.IM-B107-01
Before operating this unit, please read these instructions completely and save them for future use.
Thank you for choosing a Panasonic AC/Rechargeable Hair
Clipper. Please read all instructions before use.
Important
This clipper has a built-in rechargeable battery. Do not throw into
fire, apply heat, or charge, use, or leave in a high temperature
environment.
Using the clipper
• Check that the blades are not damaged or deformed before
use.
• Terminate the usage when there is abnormality or failure.
• Turn off the appliance before changing the trimming length or
removing the comb attachment.
• Before each use, apply oil at the places marked with arrows.
(See page 6.)
• The appliance should not be used on animals.
• Do not press the blade against the skin.
• Do not use the clipper for any purpose other than trimming.
• This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the
appliance by a person responsible for their safety. Children
should be supervised to ensure that they do not play with the
appliance.
Charging the clipper
• Never use the AC adaptor in the bathroom or shower room.
• Do not use any power cord or AC adaptor other than this AC
adaptor (RE9-36). -36)
• Charge the appliance in a location where it will not be exposed
to direct sunlight or other heat sources, at temperatures of
5 °C to 35 °C.
• Plug in the AC adaptor into a household mains socket where
there is no moisture and handle it with dry hands.
Operating Instructions
AC/Rechargeable Hair Clipper
(Household)
Model No. ER-GC70/ER-GC50
• Hold the AC adaptor when disconnecting it from the household
mains socket. If you tug on the power cord, you may damage
it.
• Do not damage or deform the power cord. Do not place heavy
objects on the power cord or trap it between objects.
• Do not use the clipper if the power cord or the AC adaptor is
worn, or if the AC adaptor does not fit snugly in the outlet.
• The power cord cannot be replaced. If the cord is damaged,
the AC adaptor should be scrapped.
Cleaning the clipper
Warning
Disconnect the power cord from the clipper before
cleaning it in water to prevent electric shock.
• The housing should not be taken apart as this can affect the
watertight construction of the appliance.
• If you clean the clipper with water, do not use salt water or hot
water. Do not soak the clipper in water for a long period of
time.
• Clean the housing only with a soft cloth slightly dampened
with tap water or soapy tap water. Do not use thinner, benzine,
alcohol or other chemicals.
• Clean the power plug regularly to remove any dust or dirt.
Storing the clipper
• Store the clipper in a place with low humidity after use.
• Do not store the clipper where it will be exposed to direct
sunlight or other heat sources.
• Store the AC adaptor in a dry area where it is protected from
damage.
• Keep the oil away from children.
2
Panasonic Electric Works Wanbao (Guangzhou) Co., Ltd.
http://panasonic.net
EN
Parts identification
a
b
ER-GC70 ER-GC50
Main body Comb attachment [A]
Dial (1 mm to 5 mm)
a. Scale marks Comb attachment [B]
b. Instruction marks (6 mm to 25 mm)
Charge indicator lamp Comb attachment [C]
Power switch [0/1] (26 mm to 45 mm)
Blade block AC adaptor (RE9-36) -36)
Cleaning lever Power cord
Moving blade Appliance plug
Stationary blade Oil
Mounting hook Cleaning brush
Travel pouch
Printed in China
0000000000 X0000-0
Accessories ER-GC70 ER-GC50
Comb attachment [A] (1 mm to 5 mm)
Comb attachment [B] (6 mm to 25 mm)
Comb attachment [C] (26 mm to 45 mm)
-
Travel pouch
-
Charging the clipper
If the clipper is losing speed, it can be fully charged in 8 hours.
A full charge supplies enough power for approximately 40 minutes
of use.
1. Slide the power switch on the main
body to the "0" position to turn off
2
the clipper.
2. Plug in the AC adaptor into a
household mains socket.
1
3. Insert the appliance plug into the
clipper.
The charge indicator lamp lights and
stays on until the AC adaptor is removed 3
from a household mains socket.
4. Disconnect the AC adaptor from a
household mains socket when
charging is completed.
When charging the clipper for the first time or when it has not been
in use for more than 6 months, please charge it for 16 hours (in
order to activate the rechargeable battery). If you charge the
clipper with the battery completely discharged, the charge
indicator lamp may not glow immediately. However, the lamp will
glow normally after charging for a few minutes.
3