Operation; Main Power Switch; Timer; Ready Light - Vulcan-Hart C24EA Series Installation & Operation Manual

OPERATION

Main Power Switch

ON The power light will illuminate, and the
generator will automatically fi ll and begin
heating to the preset temperature.
OFF The power light will turn off , and the
generator will drain.

Timer

Set to the desired cooking time, or set to the
constant position. Timer range is 0-60 minutes.
When the timer reaches 0, the buzzer sounds and
steam stops entering the cooking compartment.
Turn the timer to the off position to stop the
buzzer. If constant steam is selected, the steamer
will steam continuously, and the timer will not
time out.

Ready Light

The ready light indicates that the steamer is
ready to cook.

Cooking Light

The cooking light indicates that the steamer is
cooking.

SonicSafe Light

The SonicSafe light indicated that the ultrasonic
scale prevention is operating.

Call Service Light

The call service light indicates the SonicSafe
scale prevention is inoperable. Call your
authorized service company to make repairs.

PREHEATING

Preheat the cooking compartment when the
steamer is fi rst used for the day, or whenever
the compartment is cold.
When the ready light is on, set the timer to 5
minutes. The cooking light will illuminate. When
the buzzer sounds, turn the timer to the OFF
position. The steamer is ready to cook.
C24EA SERIES ELECTRIC COUNTER CONVECTION STEAMERS
When the compartment is preheated, place
pans of food into the cooking compartment and
close the door.
Set the timer to the desired cooking time. At
this point, the cooking cycle begins. Opening
the door interrupts the cooking cycle. Close the
door to resume cooking.
The buzzer will sound when the cooking cycle
ends.
Turn the timer to the OFF position to silence the
buzzer. Open the door and remove the cooked
food.
If the timer is set to constant steam, the steamer
will steam continuously and the buzzer will not
sound.
Set the main power switch to the OFF position.
1. Press the power switch to the OFF position.
2. Clean the compartment and door gasket.
3. Leave compartment door open.
Power supplied to the steamer
must remain on for 15 minutes after the
main power switch is set to the OFF
position. This will allow the drain cycle to
complete.

EXTENDED SHUTDOWN

To shut down for an extended period:
1. Press the power switch to the OFF position.
2. Turn off the water and the main power supply.
3. Clean the compartment and door gasket.
4. Leave compartment door open.
5. Disconnect power.
— 11 —

STEAMING

SHUTDOWN