BUTTON SELECTION SUBMENU:
Press d
Press b
Press d
If GROS was selected, in the Run Mode pressing b button causes the
display to flash Gross value (value measured without zeroing of the
display).
If PEAK was selected, in the Run Mode pressing b button causes the
display to flash Peak value.
0 - 20 mA current input used for process measurement only.
For 4 - 20 mA Input select 0 - 20 mA and adjust the Input/Reading
accordingly. To adjust 4 - 20 mA input, see example under
INPUT/READING Submenu.
3.2.5 Reading Configuration Menu
Figure 3.4 Flow Chart for Reading Configuration Menu
12) Display flashes previous selection of GROS Gross or PEAK
Peak.
13) Scroll through the available selection GROS or PEAK to the
selection of your choice.
14) Display shows STRD stored message momentarily and then
advances to RDG Reading Configuration Menu.
18