Software, Drivers, Configuration; Operating Instructions; Deploy The Unit; Button Functions - Omega Engineering HHSL-101 User Manual

Usb digital sound level data logger

Table of Contents

showing through the small square hole in the rear of the unit.

Push back the cover, insert a fresh battery in the correct

orientation, and replace the cover, pushing it forward until you

feel and hear a click.

Note: If the battery is removed from a unit before it has been

set up from software or while it is recording, the unit must be

reconfigured before it can be reactivated. If it is not

reconfigured, the unit will remain in standby mode.

Replacement "1/2 AA" batteries are available from Omega

(part no. OM-EL-BATT).

SOFTWARE, DRIVERS, CONFIGURATION

Please refer to the software manual on the CD for installation,

configuration and operating instructions.

The HHSL-101 is particularly easy to deploy on a job site

because the unit does not need to be plugged into a computer

to be activated (ready to start logging data). The HHSL-101—

with its protective cap on—can be deployed either by laying

it on a horizontal surface or by mounting it onto the stand

provided.

To turn on the device, press and hold the unlabeled yellow

Function button (Fig. 1, Callout B) for 3 seconds. If the device

has not yet been activated, this operation will activate the

device and the LCD will display Log. If the device is already

activated, this operation will deactivate the logger and the

LCD will display Con. If the memory is full, the LCD will

Table of Contents