Table of Contents
Advertisement
5.0 R
EVIEWING THE
BUTTON
DISPLAY MODE OPERATION
SEL
Index display through enabled values
RST
Resets values (MIN/MAX) or outputs
OPERATING MODE DISPLAY DESIGNATORS
MAX - Maximum display capture value
MIN - Minimum display capture value
Pressing the
button toggles the meter through the selected displays. If display scroll is enabled, the display will toggle automatically every four seconds between
SEL
the enabled display values.
6.0 P
ROGRAMMING THE
PROGRAMMING MODE ENTRY (SEL BUTTON)
It is recommended all programming changes be made off line, or before
installation. The meter normally operates in the Display Mode. No parameters
can be programmed in this mode. The Programming Mode is entered by
pressing and holding the
button. If it is not accessible then it is locked by
SEL
either a security code, or a hardware lock.
MODULE ENTRY (SEL & RST BUTTONS)
The Programming Menu is organized into separate modules. These modules
group together parameters that are related in function. The display will alternate
between
and the present module. The
Pro
module. The displayed module is entered by pressing the
MODULE MENU (SEL BUTTON)
Each module has a separate module menu (which is shown at the start of each
module discussion). The
button is pressed to advance to a particular
SEL
parameter to be changed, without changing the programming of preceding
parameters. After completing a module, the display will return to
Programming may continue by accessing additional modules.
SELECTION / VALUE ENTRY
For each parameter, the display alternates between the present parameter and
the selections/value for that parameter. The
the selections/values for that parameter. Pressing the
activates the displayed selection/value. This also advances the meter to the next
parameter.
For numeric values, press the
RST
most digit will begin to flash. Pressing the
digit by one or the user can hold the
scroll. The
button will advance to the next digit. Pressing and holding the
SEL
button will enter the value and move to the next parameter.
SEL
F
ENTERING PROGRAM MODE
Press and hold for 2 seconds to activate
PROGRAMMING MENU
button is used to select the desired
RST
button.
SEL
button is used to move through
RST
button, stores and
SEL
button to access the value. The right hand
button again increments the
RST
button and the digit will automatically
RST
B
RONT
UTTONS AND
"1" - To the right of the display indicates setpoint 1 output activated.
"2" - To the right of the display indicates setpoint 2 output activated.
M
ETER
OVERVIEW
PROGRAMMING MODE EXIT (SEL BUTTON)
The Programming Mode is exited by pressing the
displayed. This will commit any stored parameter changes to memory and
return the meter to the Display Mode. (If power loss occurs before returning to
the Display Mode, verify recent parameter changes.)
PROGRAMMING TIPS
It is recommended to start with Module 1 and proceed through each module in
sequence. When programming is complete, it is recommended to record the
parameter programming and lock out parameter programming with the user input
or programming security code.
FACTORY SETTINGS
Factory Settings may be completely restored in Module 2. This is useful
when encountering programming problems.
ALTERNATING SELECTION DISPLAY
.
In the explanation of the modules, the following dual display with arrows will
Pro
NO
appear. This is used to illustrate the display alternating between the parameter
on top and the parameter's Factory Setting on the bottom. In most cases,
selections and values for the parameter will be listed on the right.
Indicates Program Mode Alternating Display
Parameter
8
D
PROGRAMMING MODE OPERATION
Store selected parameter and index to next parameter
Advances through the program menu
Increments selected parameter value or selection
USrIN
N0
Selection/Value
Factory Settings are shown.
ISPLAY
button with
SEL
Pro NO
Advertisement
Table of Contents
