Omega Engineering i Series User Manual page 41

DATA SEPARATION CHARACTER SUBMENU:
Determines whether data sent from the device in Continuous Data Flow Mode
will be separated by spaces or by Carriage Returns.
Press d
Press b
Press d
DATA FORMAT SUBMENU:
Preformatted data can be sent automatically or upon request from the monitor.
Use the Data Format Submenus to determine what data will be sent in this
preformatted data string. Refer to the iSeries Communications Manual for more
information about the data format. At least one of the following suboptions must
be enabled and hence output data to the Serial Bus.
This menu is applicable for Continuous Mode of RS-232 communication.
Press d
ALARM STATUS SUBMENU:
Includes Alarm Status bytes in the data string.
Press d
Press b
Press d
MAIN READING SUBMENU:
Includes Main Reading in the data string.
Press d
Press b
Press d
34) Display flashes previous selection for "Separation" Submenu.
35) Scroll through the available selections: SPCE "Space" or
_çR_ "Carriage Return".
36) Display shows STRD stored message momentarily and then
advances to DAT.F only, if it was changed, otherwise press a
to advance to DAT.F Data Format Submenu.
37) Display advances to STAT Alarm Status Submenu.
38) Display flashes previous selection for "Status" (alarm status).
39) Scroll through the available selections: NO, YES.
40) Display shows STRD stored message momentarily and then
advances to RDNG only, if it was changed, otherwise press a to
advance to RDNG Reading Submenu.
41) Display flashes previous selection for "Reading".
42) Scroll through the available selections: NO, YES.
43) Display shows STRD stored message momentarily and then
advances to PEAK only, if it was changed, otherwise press a to
advance to PEAK Peak Submenu.
37