Front-Panel Error Messages; Accessories; Furnished Accessories - Shure Digital IntelliMix SCM820 Manual

Front-Panel Error Messages

An error message is generated on the Channel LED rings when operating or environmental conditions occur that could poten-
tially harm the mixer. These types of messages indicate the mixer has experienced a critical failure. Before calling Shure Sys-
tem Support, try these basic debugging tools:
1. Power cycle the device by switching the power button off and on again.
2. Reset the device to factory default settings. This will clear all configurations made to the mixer.
3. Download the latest firmware from Shure.com and load it to the device.
4. If the error message persists, contact a Shure support representative for your region.
Note: To temporarily clear an error message until troubleshooting can be conducted, simultaneously press the Channel 1 knob and Front Panel Mode selector.
Device Overheating Message
One example of an error message is the Device Overheating message. This appears on the channel LEDs in the following pat-
tern as illustrated in the drawing. For this message, it is recommended that the device be immediately cooled down to avoid
permanent damage. If the problem persists, follow the steps listed above to try to clear the message.

Accessories

Furnished Accessories

Furnished Accessories
Hardware Kit (SCM820, SCM820-DAN)
Hardware Kit (SCM820-DB25, SCM820-DAN-DB25)
Ethernet cable
Power Cable
Power Cable by Region
US
Brazil
Argentina
Europe
UK
Japan
Device Overheating Error Code
Part Number
95B8389
95A14336
95A14335
95C8247
95A8713
95B9021
Shure Incorporated
90A20082
90BA8100
95D15103
region dependent, see table
52/59