Shure Digital IntelliMix SCM820 Manual page 42

High-Shelf Filter
Phantom Power (+48V)
DFR Enable/Disable Button
Channel On Indicators
Clip Indicator
Input Meter
Channel Fader and Gain
Value
Mute Button
Aux Routing
Aux Link Mode
Input Meter Mode
For tempering sibilant speech or enhancing the sound of off-axis microphones. Use this to
boost or cut the signal by 12 dB at 5 kHz.
• Green= enabled
• Gray= disabled
When selected, the button illuminates green to indicate 48 V phantom power is supplied to
the microphone. Use this setting for condenser microphones.
Note: Disabled when Input Gain Level is set to Line (+0dB) or Audio Source is set to Network.
When Digital Feedback Reducer (DFR) is assigned from the DFR tab, an enable/disable
button appears in that channel strip.
• Green= enabled
• Gray= disabled
The two indicators illuminate green when the channel is open to that mix bus (Mix A or Mix
B). When set to Dual Mixer, the A and B indicators function separately for each mix.
Illuminates when the signal is clipping the input preamp. The light will stay lit as a warning for
2 seconds. Select a lower Input Gain Level to avoid clipping.
Displays signal level information. The meter is customizable for he following options:
• Display the input signal level (default) or IntelliMix gain attenuation.
• Pre-fader or post-fader Input signal level.
• VU + Peak (default), Peak, or VU metering of input signal level.
Adjusts the channel volume from -110 dB to +18 dB.
Mutes the audio for that channel. A muted channel still can still be soloed to the headphones
for monitoring. Channel Mute Control can be set to one of two places from the IntelliMix tab:
• Pre-IntelliMix: Audio is muted before MaxBus or IntelliMix decisions.
• Post-IntelliMix: Audio is muted after contributing to IntelliMix and Maxbus decisions.
Routes the aux channel to the selected mix output. The aux channel routes without automix-
ing to the mix outputs.
Defines the aux channel routing when the device is in a Link Group:
• Global (default): Aux audio appears at the outputs of all linked mixers.
• Local: Aux audio appears only at that mixer's output.
Determines if the channel meters are before (Pre-Fader) or after (Post-Fader) the channel's
volume knob/fader.
Shure Incorporated
42/59